oalogo2  

AUTHOR(S):

Teshome Goa Tella, Simiyu Sitati, George N. Nyakoe

 

TITLE

Finding and Ranking Load Bus Voltage Stability Severity Indexes Due to Load Reactive Power Changing Using User-Defined and Modified Voltage Stability Indices

pdf PDF

 

ABSTRACT

Recently the utility is facing severe voltage stability problems so that to satisfy end users exponential growth of energy demands. As a solution, considering high operational cost of constructing new power generation, transmission and distribution system the utility is connecting more loads on existing load buses up to their thermal limits. But in power system increasing inductive load brings voltage stability problem due to an armature reaction. Thus, if we connect an additional inductive load, the armature reaction is subtractive to the main field, resulting in voltages fall-down and hence yields further voltage collapses. In addition, since under heavy load the line absorbs more reactive power than it generates, leads to transmission line stresses and its fall down when it exceeds maximum thermal limits. Therefore, this article targets finding voltage stability margins of load buses and ranking them based on their severity indexes for reactive load power changing using user modified voltage stability indices and recommending further solutions

 

KEYWORDS

voltage stability problems, power, voltage engineering

 

REFERENCES

[1] T. d. S. João Miguel and M. d. Cruz, EXTENSION OF CONTINUATION POWER FLOW TO INCORPORATE DISPERSED GENERATION, Italy : Instituto Superior Tecnico, 2012.

[2] D. K.R.Vadivelu, "FAST VOLTAGE STABILTY INDEX BASED OPTIMAL REACTIVE POWER PLANNING USING DIFFERENTIAL EVOLUTION," Electrical and Electronics Engineering: An International Journal (ELELIJ) , vol. 3, no. 1, 2014.

[3] S. S. Lakshmi, "Voltage Stability Assessment of a Power System Incorporating Wind Turbine Using Power System Analysis Toolbox (Psat)," IOSR Journal of Electrical and Electronics Engineering (IOSR-JEEE), vol. 9, no. 2, pp. 19-25, 2014.

[4] K. P. K. Mutegi A. M and M. C. M. a. S. M. J, "Optimal Placement of FACTS Devices using Voltage Stability Indices," in Annual Conference on Sustainable Research and Innovation, India, 2016.

[5] N. I. Omer H. Mehdi, "Fast Prediction of Voltage Stability Index Based on Radial Basis Function Neural Network," Modern Applied Science, vol. 5, no. 4, 2011.

[6] J. H. a. H. R. Pota, "Robust Control for Grid Voltage Stability: High Penetration of Renewable Energy, Power Systems,," in Power System Voltage Stability and Models of Devices, Singapore , Springer Science+Business Media , 2014, pp. 1-8.

[7] V. P. G. Rajat Arora and V. K. Gutam, "A rEVIEW on-Voltage Stability Improvment by Using FACTS Controller in Power System," International Journal of Electrical and Electronics Engineering , vol. 3, no. 5, 2016.

[8] A. Sharifian, "Assess the Modeling Effects of PSS and Governor on Voltage Stability of Power System," Journal of Electrical & Electronic Systems, vol. 5, no. 3, Electrical & Electronic Systems.

[9] P. U. Parul Anand, "Voltage Stability Assessment Using Continuation Power Flow," International Journal of Advanced Research in Electrical,Electronics and Instrumentation Engineering, vol. 2, no. 8, 2013.

Cite this paper

Teshome Goa Tella, Simiyu Sitati, George N. Nyakoe. (2017) Finding and Ranking Load Bus Voltage Stability Severity Indexes Due to Load Reactive Power Changing Using User-Defined and Modified Voltage Stability Indices. International Journal of Power Systems, 2, 33-41

 

cc.png
Copyright © 2017 Author(s) retain the copyright of this article.
This article is published under the terms of the Creative Commons Attribution License 4.0